300zx twin turbo manual boost controller






















These boost jets or orifices are installed inside each of the rubber lines going to the two wastegate actuators on a zx Twin Turbo. Restricting these lines, that have pressurized air running through them while the car is under boost, decreases the pressure acting on the wastegate actuator which in turn raises the boost level that the turbos www.doorway.ru: Z1 Motorsports. 5. New Boost controller (manual) 6. NO ERROR CODES. Just 55 as it should be (even with the 2 hoses capped) Does anyone have a decient pic or diagram for vac lines? The on-line manual is impossible to follow the massive amounts of vac lines off the solenoids under the cruz control. 7. No smoking 8. No gas smell, 9. No abnormal knocking  · you can't turn down the stock boost levels without bypassing the stock saftey boost valves the only real difference in setting up a boost controoelr on the Z32 is that you either need to manual controllers (impossible to set them in perfect ballance) or 2 electronic solenoids hooked to an electronic controler or you "T" the vac lines into a single manual boost .


ADD W1 Manual TURBO BOOST ADJUSTABLE CONTROLLER COLOR RED (Fits: Nissan ZX) $ Free shipping. or Best Offer. Only 3 left. Dual Core Radiator fits Nissan ZX Z32 Twin Turbo MANUAL ONLY 2 Row 2" (Fits: Nissan ZX) $ fits ZX Twin-Turbo FMIC Side Mount Intercooler Upgrade Replacmenet OE (Fits: Nissan ZX). The boost controller interrupts the pressure line that runs into the wastegate actuator, allowing you to increase boost over stock levels. Step 1: Find your wastegate actuator which is usually attached to the turbo, unless you are using an external wastegate. The wastegate actuator will have a vacuum line port that runs to a boost source. In this video, we show you how to install a manual boost controller! This is very easy to do, and Turbonetics sells the exact ones you see here on eBay for u.


The stock twin turbo Z32 has a basic boost-control system from the factory which basically allows to stages of boost pressure to be produced. Under normal operation, the system produces approximately PSI of boost. The installation is pretty much the same as any other boost-controller, but I just felt like doing a tech-article ;-) As usual, also this boostcontroller comes with hoses and pieces for a car with a single turbo so before you start off, go buy at least 2 T-pieces, m/5ft rubber-hose and a few clamps. The Nissan ZX Twin-Turbo has one of the most powerful engines created for Nissan Cars. The VG30DETT has huge amounts of potential. This engine is putting out hp and almost foot Lbs. of torque stock! The twin turbocharged and inter-cooled engine lacks very little. Read on to find the 5 most cost effective modifications to give you the most horsepower for your hard earned dollar!.

0コメント

  • 1000 / 1000